Martial Arts Patches – Unique Information On This Issue..

Embroidered patches can be dated all the way back to ancient Asian civilizations; they have been around for centuries. Yet not until recently has it been possible to place them to your clothing using a hot iron and heat-activated glue. With today’s patches you can readily apply them on many fabrics without ever needing a needle and thread. Thankfully having the ability to affix them with a hot iron implies that your fingers are not going to get sore and it is easier and quicker to do. The only issue is, you can’t iron patches to leather – at the very least within the traditional sense.

When you’re using a hot iron to connect embroidered patches you’re essentially warming up the glue on the back side till it reaches a semi liquid, tacky state. That requires a lot of heat; heat that can damage the sensitive finish of leather.

Custom Military Patches

It’s factual that leather is an extremely durable material, but the surface is comfortably damaged by concentrated heat sources. This presents two problems. The initial problem would be the fact if the leather is damaged, the glue are not likely to stick to it and then the patch will fall off. So when the patch does fall off, the leather will be left having an ugly mark where iron has burned it. The same can probably be said for vinyl and various faux leather. One more thing to consider is the fact even though you might find a way to make the glue adhere, one slip of the iron that brings in contact with bare leather will leave a burn mark. This is the reason you need to not have a hot iron anywhere near your leather.

We said earlier which you can’t make use of an iron to place embroidered patches to leather inside the traditional sense. The explanation for saying this is because that although you must not try to place iron on patches to leather in the traditional way but there’s a non-traditional method. Therefore there is special glue that you can use in addition to an unheated iron. Yes, a smeynb iron. It will only be important to use your iron as a press.

In order to get this to operate properly, you need to have special glue; leather is notoriously difficult to do business with which means you won’t have the ability to use just any old glue. You can find this specialized glue at craft stores, sewing shops, and also some high-end leather goods specialty stores. Just be certain you carefully look at the directions on the bottle, being sure that use on leather products is specifically mentioned. Failure to achieve this could mean that you’re just going to be squandering your money.

The glue has to be put on the rear of the patch according to the instructions on the bottle and then you should carefully place the patch to the part of the leather where you want it. Next thing you need to do is make use of your cold iron to press down firmly on the patch for the amount of time mentioned previously on the glue bottle. After that you can release the iron and wait for glue to dry. It’s essential that you know where you would like to have your patch before you decide to lay it down. You will be left with an ugly stain should you eliminate the patch after you might have placed it onto the leather.

Leave a comment

Your email address will not be published. Required fields are marked *

We are using cookies on our website

Please confirm, if you accept our tracking cookies. You can also decline the tracking, so you can continue to visit our website without any data sent to third party services.