LED Dimmable Driver – Explore This Site ASAP To Choose Extra Particulars..

If you are planning on installing LED strip lights (also called LED tape) you need to be able to accurately calculate the power required. Having insufficient power source will cause only some (or none) of the LEDs illuminating, or can cause irritation flicker. An over specified power source will cost more to buy, and will also be harder to fit as they are bigger.

To calculate the ability supply needed for your LED driver, you must know: Length of the strip or tape, Number of LEDs per metre, Power consumption per LED. To calculate the size of power supply (in Amps) you should multiply the length of the LED tape by the number of the LEDs per metre and after that multiply this by the strength of the LED (.08w to .24w per LED are typical values). Then divide the benefit by 12 volts to calculate the desired Amperage in the power source.

(Length of LED Strip x LEDs per Metre x LED Power) / 12 We recommend you add at the very least 10% for the calculated value to permit for resistance and losses within the cables. You will also need to permit any possible expansions or additions in the future. Most LED Strip Lights may have additional sections added using joining cables.

Calculation Examples: Example 1: A 5m roll of SMD3528 (.08w) with 60LED/m could be: (5m x 60 x .08) / 12 = 2amps 10% = 2.2Amps. Example 2: A 5m roll of SMD5050 with 60LED/m would be: (5m x 60 x .24) / 12 = 6amps 10% = 6.6Amps.

For virtually any LED strips over 2 metres long you are able to provide a 12volt feed to both ends from the strip or one feed in the middle, by cutting the strip into two and connecting the ability supply to both strips. This provides a far more even power distribution and really should offer a more consistent illumination.

LED Strip Light Uses – There are 2 premiere factors behind using LED strips. The initial one is efficiency – LED driver ul are extremely efficient, with a lot of the power likely to produce light, not heat. Their extremely long life (20,000 hours is typical) means that they also do not need replaced often, ultimately causing vastly reduced lifetime costs.

Another reason is aesthetic. Leds can be created extremely small – some LED lighting strips are as thin as 4mm – therefore can be set up in places where traditional lights would not fit. Enhance this the many LED colour options, including RGB LEDs with remote controlled colour changing abilities. This gives a new range of possible lighting effects that will dramatically change the style of a room.

Unlike other traditional lights which require bundles of cables and drain a lot of power, LED lights tend to be much easier to use and easy to install. The cluster of those miniature size lighting is fixtures produced in such hapmys efficient way they are capable of illuminating any area of your liking. Installing Leds within your commercial or residential application can help keep environment green, save your energy cost and above all, causes you to a wise owner who follows latest technology trends.

Every lighting technologies have some attributes that determines its nature and requirements of installation. Similar is the case with LED, you need to think, decide and plan precisely to have LED Constant voltage drivers properly installed in your area. LEDs uses are versatile and thus its type and specifications will also be varied in accordance to the application. LEDs are applicable both in dry and wet areas, knowing the proper fixture available for each will really create your installation process easier.

Leave a comment

Your email address will not be published. Required fields are marked *

We are using cookies on our website

Please confirm, if you accept our tracking cookies. You can also decline the tracking, so you can continue to visit our website without any data sent to third party services.